View Full Version : L298HN connection in circuit

03-18-2008, 12:52 AM
I am new to this board however I am in the process interfacing the L298HN on my breadboard. Nothing happens motor did not made a single turn and I measured couple of current at different nodes in the circuit the current reading did not make much sense to me .
On top of that using a bread board seem to be even worst prototyping. Should this chip be soldered ?
any ideas how to go about ?

03-18-2008, 08:56 AM
hi rick

can you please explain a little about your setup... what pins have been connected to what.. and about your voltage supplies.. how you are routing the power to the IC at what pins..

in short.. you can make your and our life easier by posting the schematic..