View Full Version : AVR-ISP Programmer for all Atmel AVR Microcontrollers by Ser

07-03-2004, 10:04 AM
AVR-ISP is low cost serial port programmer for Atmel AVR series microcontroller to perform In-Circuit Serial Programming(ICSP) also called In-System Programming(ISP) without removing the microcontroller from the target board. AVR-ISP sends and receives data through serial port thus simplifying and speeding the programming task. Complete erase, fuse config, reading, writing, locking is done without touching the hardware, truly touch less programming. When programming software wants to communicate with microcontroller, it puts the AVR in programming mode by putting the RESET pin low and sending programming enable instruction. The data is now exchanged using serial in and out pins of AVR through serial port.


Visit here to purchase in auction for just 1/- rupee

08-01-2004, 10:59 PM
The Direct URL is this now, if you are interested,



08-02-2004, 12:28 AM
If you got the time you can make your own also (Check the avr for beginners series of tutorials )
will cost about Rs 20-30