PDA

View Full Version : I want to design PCB



crownabhisek
02-17-2010, 10:47 PM
Which type of Store shall I go for to get the following materials...
Copper clad laminate

FR4 laminate 1.6 mm thick (35um copper)
Etching solution

Ferric chloride solution,
about 1 liter/ 0,26 gallons
Thinner (e.g. acetone)
blade cutter
scotch tape
kitchen paper
cotton wool
vice
hacksaw

shakerobo
02-18-2010, 10:42 AM
hey dude,

do not get so complicated on etching ,just follow the instruction's given by vikas on etching your own board using fecl3(using locally available supplies).but if u want to do etching for selling something or etc.......u can do it from locally etching shops(either online or nearby)