View Full Version : Need help to reset ATmega 128

11-26-2016, 05:38 PM
I have UniBoard v1.1 (AVR AtMega128 Development Board)
It got inbuilt USBasp programmer & I am using eXtreme Burner software

It was working fine but suddenly now the software is giving error “Power on failed cannot communicate with the Target Chip”

The last program which I burn is working perfectly fine.
I feel I have made some mistake with the fuse bit and due to that I am not able to program the Atmage 128 again.

I search on net but most of the topic is about attiny microcontroller
Can anybody help me to reset the atmage 128