PDA

View Full Version : Program Microcontrollers without a programmer...



daaBRAT
08-09-2004, 10:38 PM
This is a great way to start guys!


AEC Electronics In-System Programming (ISP) Software enables a PC to program Atmel's AT89S microcontrollers while soldered in onto the PCB. A simple 5-way cable (that you can easily make yourself) is connected between the PC's printer port and the target hardware. This DOS program is small (zipped to around 50KB) and fast. Programming algorithms have been optimised so that programing time is not machine dependent. These routines have been re-engineered to be even faster by only programming bytes that need programming. So, if a small program change is required during devepolment (and the device is not erased before re-programming), programming can be a fast as program verification!


http://www.aec-electronics.co.nz/software.htm

subzero
08-09-2004, 10:51 PM
Anyway some updates

all atmel avr 90sXXXX ( avr core ) series support ISP ( read the tutorials on the website )

also AT89S8252 ( 8051 core ) supports ISP :)

By the way pony prog is all u need ... www.lancos.com or .org i think :)

daaBRAT
08-10-2004, 12:16 AM
How should I say it.... ?

Look MA no HARDWARE!