Your browser does not support iframes.
We at RoboticsIndia(@baseapp) are planning a new project to work on , like the title says the lowest cost breadboard friendly linux Core board. The whole idea is to put the full BOM + Fab under < USD 25 at say 100x quantity. Rasperry pi is great , but i cannot duplicate it or ship it inside my product to a client. BGA is not cheap. So the Ideas is to make a low cost mbed like board which can run linux and the user can put inside product or develop ...
I wanted a single sided motor shield which would allow me to control a few servos and 2 DC Motors. All this while allowing easy sensor interfacing. The shield had to be single sided and DIP for DIY. The shield given below is the result for the same. Some Features - Dual DC Motor support with PWMServo motor supportDIY Single sided PCBEasy sensor interfacingStackable Ideas for improving it are ...
These Days im building a Balancing Robot so here are step wise how to interface a arduino to Accelerometer and Gyro Things ive used 1. ATmega8 Arduino ( ARP 1.0u) 2. DIY Proto Shield 3. 3.3V Zener + 330 Ohm for 3.3V supply 4. Triple Axis Accelerometer Breakout – MMA7260 ( @Sparkfun ) 5. Gyro Breakout Board – LY530AL – 300°/s ( @Sparkfun ) The Gyro and Accelerometer were bought from Feemo India , as i found them the cheapest retailers ...
Updated 02-06-2010 at 12:41 PM by vikas