Your browser does not support iframes.
Entries with no category
I make prototypes of single sided PCB's at home before i send them over to a PCB maker , So here is a quick Tutorial of what i do ...
Things you need -
1. Ferric Chloride
2. Copper Clad Board
3. Laser Printer
4. Fine sand paper
Step 1. Print layout on glossy paper and cut a Copper Clad PCB accordingly. Use fine sandpaper to clean PCB. Leave extra edges around layout , it helps in transfer.
Updated 01-31-2010 at 06:12 AM by vikas
Something i think which would be really suitable in the Indian environment. It has jtag , usb connectivity , 32 kb uC running at 16 Mhz with good I/O pin count among features.
The STM8S-Discovery kit, is the cheapest and quickest way to discover the STM8S, to build and debug the application, and to program and use the device.
Read more about it here - http://www.st.com/mcu/contentid-130-...DISCOVERY.html
Updated 01-01-2010 at 10:12 PM by vikas
Ive added a new section called world news , All good Robotics related sites are hopefully covered. If i missed out any please point them out.
Ive added new Robot Avatars to the site , you can check them out in edit avatar in your profile page.
Welcome to the new blogging system at Robotics India