Good method for prototype boards
Thanks for the tip.
@vikas: if you pre heat the copper clad board before putting the printed sheet on the toner gets transferred very nicely even .5mm tracks......
Thank you so much for your valuable information
Hi Prashant, Nice to see that RI has become so popular and acheived great PR. congrats to you and Vikas :-)
There are currently 31 users online. 2 members and 29 guests
Shop An online shop selling basic stuff you need to get started at affordable rates. This will carry our own... ...
Welcome to the new Robotics India. It has been 4 years since the last upgrade, and Robotics India was in need of one... ...
From 14th Sep 2010 to 18th Sep 2010
Yes sure (2 Votes)
Iam not sure (0 Votes)
Too costly (0 Votes)
No (4 Votes)