Results 1 to 4 of 4

Thread: can i connect l297+l298 directly to a microcontroller?

  1. #1

    Default can i connect l297+l298 directly to a microcontroller?

    hai....
    can i connect l297+l298 directly to a microcontroller or i need to connect it to a compuer and run it....
    if i can do so.... i need the circuit for the same.... pls help me out.......

  2. #2
    Senior Member T-1000
    Join Date
    Mar 2005
    Location
    Bangalore
    Posts
    728
    Blog Entries
    7

    Default

    hai....
    can i connect l297+l298 directly to a microcontroller
    yes you can
    eventhough you might not necessarity require a controller if you are using an L297. depends on your application, which you did not mention.

    i need to connect it to a compuer
    this means you dont know how these chips work..
    READ the datasheet.
    Yes, READ it.
    Again, READ it.

    I repeat because no one READS it!! :evil:
    The circuits are in the datasheets.!!!!
    .... I didnt do it ! ....

  3. #3

    Default

    im going to use it with a microcontroller only.... coz i hv to run 3 stepper motor... so how can i connect it to a microcontroller???? can u pls send me the circuit 4 de same????

  4. #4
    Senior Member T-1000
    Join Date
    Mar 2005
    Location
    Bangalore
    Posts
    728
    Blog Entries
    7

    Default

    see

    i wrote READ three times.. still he is asking to send him the circuit diagram...
    :evil: :evil: :evil:

    IT IS IN THE DATASHEET !!!!
    .... I didnt do it ! ....

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •