Results 1 to 2 of 2

Thread: ULTRASONIC SENSORS

  1. #1

    Default ULTRASONIC SENSORS

    Hi

    I am designing a ultrasonic range finder.

    I found some circuits avaliable on the net. There is a section on the transmitter circuitry that confuses me. I am using microcontroller to generate a 0 - 5V 40KHz burst of pulses. I want to boost the signal to have a larger voltage swing, and current drive to achieve larger power transmission hence further distance. I can amplify the voltage to 0 - 9V, but now how do I achieve a -9V to 9V swing?

    The circuit uses hex inverters. Doesn't a hex inverter represent a logic 0 as ground? The explanation given about why two hex inverters are in parallel is still not clear to me.

    http://www.interq.or.jp/japan/se-inoue/e_sonic1_3.htm
    (Ultrasonic drive circuit)

    I am using a PIC microcontroller, which drives out about 20mA. I want to achieve the max power transmission for a 40KHz piezo transducer. For current amplification, how does one design this for a -9V to 9V signal?

  2. #2
    Senior Member Android
    Join Date
    Jan 2008
    Location
    KGP
    Posts
    104

    Default

    Simple ... use MAX232 ... it generates +-9V ... give complimentary uC outputs to (T1IN,T2IN) inputs of MAX232 and connect its outputs (R1OUT, R2OUT) to transmitter. You will nicely get +-9V swing.

    By the way, it is always better to improve sensitivity of receiver than increasing transmitter power.
    For every minute that is spent in organizing, one hour is earned !

    http://elecrom.wordpress.com/

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •