Results 1 to 3 of 3

Thread: embedded c code for interfacing zigbee with atmega 16

  1. #1
    Junior Member Newbie shivangthebuddy's Avatar
    Join Date
    Mar 2010
    Location
    Bareilly, U.P.
    Posts
    4
    Blog Entries
    3

    Default embedded c code for interfacing zigbee with atmega 16

    hi.i just wanted to knw embbeded c code for interfacing zigbee with atmega 16 and interfacing lcd with atmega 16

  2. #2
    Senior Member Cyborg
    Join Date
    Nov 2006
    Location
    Bangalore, india
    Posts
    244

    Default

    if you are talking about zigbee modules by maxstream/digi then its just a serial port communication for very basic communication. ya if you want do some hoping and some other, then its still is an serial communication but with AT commands.
    so what’s your specific need?
    Nikhil Chandra | Bangalore

    Imagination is more important than knowledge.

  3. #3

    Default

    if u configure zigbees in AT mode, u can use simple uart
    but configuring them is the problem atleast not a big problem though
    this was the most useful resource which i found during robocup prep first get thru this
    blog.kevinhoyt.org/wp-content/xbee-setup.pdf

    the second part is the uart which if ur unfamiliar isnt that difficult and hardly takes a day or 2 to master

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •