Results 1 to 4 of 4

Thread: ADC interface with load cell

  1. #1

    Default ADC interface with load cell

    Hi All,
    I am facing a common problem, but I don't know how to solve it. I am interfacing a load cell to a pic 18f452 ADC. I am using a opamp with a gain of 470K. Now the problem is. If I reduce the gain then the minimum weight I wish to sense is not sensed by the circuit due to the limitations of the ADC. And at this high gain the noise distortion is so much that I am not able to get any stable readings. What is the solution? Will a low pass filter (RC filter) solve the problem. What should be the cutoff frequency for which I need to design this filter?
    Thanks in Advance waiting for your replies
    kind Regards
    suchitra

  2. #2
    Senior Member Cyborg
    Join Date
    Apr 2007
    Location
    Mumbai
    Posts
    213

    Default

    gain of 470K in single stage seems to be horrible. In fact which scheme you have to adopt can be cleared only when you post some details of load cell.
    However why don't you select the load cell of 4-20mA output signal. This will reduce you problems to great extend.

    Also if you want to do it your self then you need precise instumentation amplifire and OP amps along with high grade shielded cables.
    Last edited by Ulhas; 04-26-2010 at 08:50 PM.

  3. #3

    Default

    Hi
    My gain is 470 and not 470K sorry for the typo. The load cell I am using is a micro load cell whose rated output is 2mv/v. And the excitation voltage is 5 V.
    I am using TI's opamp OPA333 in non inverting mode. with Rf = 470K and R1 = 1 K. What do you exactly mean by a load cell of 4 to 20 MA? Is it possible to give further details about it especially the price.
    Kind Regards
    suchitra

  4. #4
    Senior Member Cyborg
    Join Date
    Apr 2007
    Location
    Mumbai
    Posts
    213

    Default

    Hi
    See this "http://news.thomasnet.com/fullstory/11844"
    In price it may be costly but reliable. Let us know about your application details amd the datasheet of your finalised load cell so that it can be explored further.

    However if it is strain gauge based then go for National Instrumentation amplifier ics.
    Look here too "http://focus.ti.com/paramsearch/docs/parametricsearch.tsp?family=analog&familyId=1612&u iTemplateId=NODE_STRY_PGE_T"
    Order free samples.

    see this and get the cost http://www.ajinkya.in/measuring-instrument.html

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •